The SilverStone Permafrost Series AIO Coolers

Aside from the obvious difference of a larger radiator, all three versions of the Permafrost cooler are practically identical. The core design of the coolers is the typical AIO configuration of a single radiator, two hoses, and a block that combines the CPU contact plate and a miniature liquid pump. The designer went with standard rubber tubes with external nylon sleeve braiding for additional protection, which are fixed on the radiator and partially adjustable (just a couple dozen degrees sideways) on the CPU block.

SilverStone focused their design efforts on the main block assembly. The company installed a three-phase engine pump and an AEC-Q100 sine wave generator, increasing the efficiency and lowering the noise output of the pump itself. The AEC-Q100 is certified by the Automotive Electronics Council, thus SilverStone is marketing it as an “automotive grade” generator. We can only agree that it is a high-quality part. The designer also installed a micro-channel copper block and made sure to thermally separate the input and output in order to prevent heat creeping.

The top part of the main block assembly is a real acrylic mirror that hides RGB LEDs. Once lit, the LEDs form SilverStone’s logo on the mirror. The user can adjust the lighting effects, colors, speed, etc., but cannot change the illuminated shape in any way.

SilverStone also claims that their radiators are “automotive grade”. That may be accurate regarding the corrosion protection and/or the material of the radiator. In terms of size, however, even the largest 360 radiator cannot be used as a cooling radiator in any kind of car – it hardly has the mass to be used as a heater core in a very small car. Though this is of no real concern to us, as the Permafrost is going to be used to cool PC processors, not a combustion engine.

On topic, the radiators are typical dual pass cross-flow designs, with tiny fins soldered on thin oblong tubes. This is by far the most dominant radiator design for AIO systems and rightfully so, as it offers the best efficiency within limited proportions and for the temperature differences that AIO coolers have to deal with. The radiators are just 26 mm thick, meaning that the entire assembly with the fans requires only 51 mm of clearance, maximizing compatibility.

The bottom of the main block assembly reveals a sizable, square cooper block. It is neither nickel-plated or polished down to a mirror finish, yet the finish is very smooth and free of imperfections. Do note, however, that these coolers are meant for mainstream desktop processors rather than large HEDT processors; so the contact plate is not large enough to cover Ryzen Threadripper processors and SilverStone does not provide hardware to install any Permafrost cooler onto a TR4 socket.

SilverStone’s application of RGB lighting on the cooling fans is exceptional. The designer placed the LEDs into the fan’s engine, creating a fantastic diffusion visual effect on the fan’s semi-transparent blades. If connected to a compatible motherboard, both the fans and the main block will copy the programmed lighting theme of the system. For those who do not own a compatible motherboard or just do not want to have lighting synergy between different parts, the lighting effects can be programmed from the wired controller, meaning that the user will have to open the case in order to access it.

Introduction, Packaging & Bundle Testing Methodology
Comments Locked


View All Comments

  • Arbie - Wednesday, June 17, 2020 - link

    I have added a link to the analogous AT test of the Noctua NH-D15 air cooler. The Fractal S36 here is apparently its equal, while the SS PF360 is some 30+ percent better than the Noctua in these metrics.

    However, even with this advantage water is a niche within a niche (OC) within a niche (DIY enthusiast). Most of the very few who try it will only do so once.
  • PeachNCream - Wednesday, June 17, 2020 - link

    Kind of agree. Most of the people that cross the bridge over to liquid cooling only do so once. Twice for me - one time to get a 100MHz Pentium SSS CPU to reach a stable OC of 133 MHz and once more to torture a VIA 1GigaPro when I was first starting to transition from going all out with as much computer power as possible to a point where I started to enjoy doing everything on as little thermal and energy (and eventually financial cost) demand as possible.

    Air cooling is more than enough and the reasons for liquid cooling generally settle somewhere far away from sufficiently fast computing. People buy them to instill in themselves a sense of satisfaction, of self-worth, of achievement, and so forth. For those seeking intangible rewards, I think, it is worth pursuing in order to tell others about the cooling and at least show photos or talk about how a CPU that would otherwise only turbo at peak speeds for 1 second is doing so for 8 seconds or how the temps are down a full five degrees when they were already far away from the maximum safe tolerances of the hardware or even how it will extend the CPU's lifespan when, ultimately, an upgrade would replace it with a newer chip long before something like that would ever matter.
  • BenSkywalker - Wednesday, June 17, 2020 - link

    Cleaner, cooler, quieter.

    Air is hotter, louder and far more cluttered.

    The anti water crowd is bizarre. You don't like it for whatever reason, so you argue the reality that it is just plain better. Modern high end air is *good enough*, and it is cheaper, but it is louder and less effective.

    You'll only go water once....? After my first build every enthusiast grade build I've done has been under water, at this point it's easier than dealing with the monstrosity of air coolers- admittedly that is due to cases now being designed for water(used to be a pain).

    This FUD campaign against AIOs is absurd, they are just plain better at the cost of being more expensive.
  • ses1984 - Thursday, June 18, 2020 - link

    Water is noisier. Pumps are noisy.

    The advantage of water is that you can have a radiator somewhere other than directly over the heat source.

    Whether you are using air or water, the heat still had to go somewhere. You still have to blow air over fins. The steady state temp under load will be equal between air or water given the surface area of radiator fins.

    If you want a giant radiator in a small case, you need to go water so you jam a 360mm radiator on the side of the case.

    Please be aware that if you have a full size atx case where you can fit a giant air cooler over the CPU, it will for sure be quieter because it doesn't have to run a water pump.
  • BenSkywalker - Thursday, June 18, 2020 - link

    Where did you get the idea that pumps are noisier than fans...? We have tons of reviews with measured sound levels, can you link any that show a plump being louder than a fan?
  • Dug - Thursday, June 18, 2020 - link

    "Air is hotter, louder, and far more cluttered"

    You don't know much about air cooling, do you?
    How in the world is a heatsink more cluttered than a radiator, with hoses, and more wires.

    My 3800x oc'd on air never goes over 72c and is quieter than any pump made. Even if water cooling could make it cooler, it doesn't get me anywhere. The CPU will run the same.

    The only issue with air is that a lot of cases are very poor in design, and users don't know how or where to set up their fans properly.

    And dealing with the monstrosity of an air cooler? Apparently tightening down two screws is harder to deal with than the maintenance of water cooling?
  • BenSkywalker - Thursday, June 18, 2020 - link

    My radiator is underneath my motherboard, I have my hose and block visible. Again, air is more cluttered.

    Oddly enough I also have a 3800x, 66c is where it maxes after stress testing for about an hour, normal use it rarely hits 50c.

    Swapping RAM in and out is a snap no matter what slot it's in, never have to worry about VRM clearance either, in fact I don't even glance at those factors when selecting a motherboard.

    Even if I were to use the stock cooler that came with my processor, we glanced at what it would look like, things start getting tight and that is certainly more compact than a decent air cooler.
  • PeachNCream - Thursday, June 18, 2020 - link

    You end up exchanging the same amount of heat with air at some point even if you do use liquid to transfer it - thus you still have to push air over a finned metal mass somewhere in the process. Yes fluid density is higher and its easier in some cases to put it in a situation where dispersal is more effective, but the point I'm making is that there are few instances where it is a necessity to do so when operating consumer computing equipment. In a home PC, liquid cooling is done more for emotional rather than practical reasons as you can see by your own defensiveness and the highly charged responses of others that feel threatened by observations that point out the benefits are somewhat limited and generally not significant improvements beyond feelings and emotions.

    Some people will happily argue that smaller cases require liquid cooling. Well, smaller cases are an end-user choice as most of us ultimately live in a sufficiently large living space so that something with higher interior volume is workable. Even Hong Kong closet apartments generally have the cubic volume necessary to handle a MicroATX PC, though I can rationally see why many residents there use only a smartphone or are in economic situations that make any compute technology out of reach. Still, small cases that mandate water cooling due to high wattage component selection - that's also a personal choice just like liquid cooling and one that boils down to feelings and emotions.

    It's the same for lots and lots of other purchase decisions people make on an on-going basis. Most are emotionally driven. There is no shame in admitting that is the case as we all constantly use mainly our emotions to make choices. You like the idea of liquid cooling. It gives you the right feelings from which you derive joy. Don't worry about it in that case. Buy what you like with your own income and don't be bothered by the rest of us that don't see a tangible benefit.
  • BenSkywalker - Thursday, June 18, 2020 - link

    Emotional? It's cooler and quieter.

    You are using emotion about your feel feels, we are quoting measured readings.

    Furthermore, this is an article about liquid cooling, why jump in if you are some air zealot? That sounds rather emotional to me.

    Liquid runs cooler, liquid runs quieter. You want to run a potato build all the power to you, you won't see me trolling a potato build article saying you need to drop a few grand for an acceptable machine.
  • PeachNCream - Friday, June 19, 2020 - link

    I don't build computers, friend. Not these days. I haven't had a desktop PC in a number of years and my couple of laptops are an Acer Aspire ES1-111M-C7DE (Linux) with a RAM and SSD upgrade and a Dell Latitude 3160 (Win10) also with aftermarket RAM and SSD. Neither even has a fan as they both use low TDP CPUs. I'm just here to chatter with the less aggressive folks in the comments box mainly about computer security, which was what my opening post about this particular cooler was concerning if you'd like to circle back around and take a look. There's little reason for me to invest much feeling one way or the other in liquid coolers though I do see significant emotionally-driven influence in your responses. As I maintained earlier, it's perfectly find that you have those feelings and operate with them, but I do find it a bit disappointing that you allow yourself to be so blinded by emotion that you attempt to impress an opposing bias on someone else so you feel as though it creates in a uninvested bystander, a nemesis worthy of your ire.

Log in

Don't have an account? Sign up now